Advertise Here
Piggybacking Reloadable Mortar Shells & Mines
Note: When using this Professional Technique please use extreme caution. This is a proven technique. By using this technique you acknowledge that Fireworkinfo.com is not responsible for any accidents while using this technique. If you are confused about any part please email us to clarify what to do.
Rules for using this technique: You must follow these directions word for word. Do not substitute any other mortar pipes than what are used below.
1. Use only at least a 15" HDPE mortar.
2. Do NOT load more than 2 shells in at a time.
3. Make sure that the mortar is very secure.
Directions:
| 1. Cutting the fuse on the mine The first step in using this technique is to prepare the mine. Cut the fuse of the mine at an angle, roughly where it would be when you bend the fuse over the top edge. |
|
| 2. Tape the fuse to the top of the mine. Center the fuse on the top end of the mine and tape making sure that the exposed powder core is facing up. |
|
| 3. Load the mine. Load the mine like normal into the mortar. |
|
| 4. Loading the top shell. Load the top shell just like normal. |
|
| 5. Light the fuse. Light the fuse to the shell. When the shell is launched it will ignite the mines fuse. When the shell is almost ready to break the mine with shoot out of the mortar. Both items with will go off about the same time. |
Please Note: Even though this technique is reliable, should the
shell not
light the mine wait at least 5 min. before approaching the mortar.
Please remember that you should not look directly into the mortar. Use extreme
caution while using this technique.